Night Marking Telecommunication Towers Solar Obstruction Light - Applications: Obstruction light for a wide variety of cranes used in Harbors, Metallurgies

Night Marking Telecommunication Towers Solar Obstruction Light - Applications: Obstruction light for a wide variety of cranes used in Harbors, Metallurgies

1.      Main parameter

Light source	LED	Emitting color	RED
Light intensity	2000cd(±25%cd)	Power consumption	≤10W
Operation voltage	DC4V	Voltage frequency	50HZ/60HZ
Lifespan	≥100,000h	Working mode	Flashing
Light controlled sensitivity	50～100 lux	Flashing frequency	20 times /min
Operation temperature	-40℃～+55℃	Operating humidity	≤95%
IP Grade	IP65	Net Weight	4.6Kg
Battery full charging	Expose to sun 30hr

Solar panel parameter (25℃ standard candles)
Over size	266mm ×262mm×5mm
Power consumption	11W
Operating voltage	4V
Open-circuit voltage	4.72V
Operating current	2.75
Short-circuit current	3.03A
Withstand level	1000V
Structure type	Stainless frame, tempered glass sealed
Lifespan	20years

2.      Installation：

This type of light is whole-construction. When installation, use the 4pcs of matched screws (M10) to tie the lights to the steel frame. Make sure screws are tightly tied.

It is necessary to pay attention to the direction of the solar panel. When the lights are use in the Northern Hemisphere, the panel faces to south. When the lights are use in the Southern Hemisphere, the panel faces to north. Then it can make good use of the solar panel. Meanwhile, around and above of the solar panel installation location must haven’t any obstructions, so as not to affect the energy absorption of the solar panel.

On the side of the lamp base, you can see a red button switch（Operation switch）, press the red button down, the light will flash for a short time, after about 5 seconds, the green LED will be on (it means the lamp has begun work normal). When you need to close the lights, turn the red button back, after about five seconds, the green LED will be off (it means the lamp is closed). In order to keep the battery have a longer stock time, pls make sure the red button switch is off and the light is closed during storage time. Only when you installed the light then open the red button switch.

 

3.      Test :

If the test is taking in the daytime, pls use the opaque materials which square is more than the solar power panel to cover the solar power panel; if test is taking under the sunshine, it even need to cover the bottom of the solar power battery, make sure no lights can shine to the solar power battery, after 10 seconds, the lights start flash working; but when the light put into use, pls don’t cover it.。

4.      Attention:

To avoid affecting the lamp’s regular use and communications, the lamp needs to be installed more than 2 meters from the transmitting antenna and to avoid the strong radiation areas when need installed on the television transmission towers, radio towers, cell phone base stations which with strong radiation tower.  If the transmitting power of the base station is higher than 500W, the lamp must be installed more than 3 meters from the antenna.

Besides, in order to avoid being struck by lightning, the lamp is prohibited to install on the top or the edge of the architecture.